– 6 –
Control Settings and Options
Automatic One-Touch Washing
The Load Sensing feature automatically senses the size of your load, fills with the appropriate amount
of water, and calculates the amount of wash time required to complete the cycle.
To choose the automatic Load Sensing feature, press POWER ON. The following indicators will light up
automatically: NORMAL WASH, LOAD SENSING, and COLD/COLD. Then simply press START/PAUSE.
To Choose Your Own Cycle Selections
1. POWER ON/OFF
Press the POWER button to turn the control panel ON.
2. WASH OPTIONS
Choose the wash option to be included in the cycle. Press the WASH OPTIONS button until the
indicator by the desired option to be included is lit. No more than one option can be selected.
• PRESOAK - This option can be added to the WASH CYCLE selected. It should be used for heavily
soiled clothes that need to be soaked before washing. PRESOAK light goes out and NORMAL
WASH light is illuminated when presoak cycle is complete.
• NORMAL WASH - This option is automatically selected when POWER ON is pressed.
• RINSE ONLY - This option may be used to add up to 4 additional rinse cycles to the WASH CYCLE
chosen.
• SPIN ONLY - This option is recommended for washable woolens and sweaters. It will extend the
spin without stretching the knit.
CLOTHES CARE CYCLE SELECTION
PRESOAK
NORMAL
WASH
RINSE ONLY
MEDIUM
LARGE
EXTRA LARGE
COLORS
HOT/COLD
TIME
REMAINING
WHITES
WARM/WARM
WARM/COLD
COLD/COLD
MIN
QUICK WASH
DELICATES
LOAD SENSING
SPIN ONLY
SMALL
LOAD
SIZE
WASH
CYCLE
TEMP
WASH/RINSE
WASH
OPTIONS
START
PAUSE
POWER
ON/OFF
GEA00041
The washer is designed to operate with hot and cold water. The user can tell by a glance at the LEDs
what is going on in the washer. Improved operation of this unit has been simplified by using MICRON
(tactile) type touch buttons. This load sensing unit utilizes a fuzzy logic electronics package to automati-
cally set the water level.
To Next Page
Loading...
Need help?
General
