Installation instructions
iNSTALLiNG THE WASHER
1. Run some water flom the hot and cold fimcets to flush
the wamr lines and rein(we particles that might clog up
the wamr valve screens.
2. Remove file inlet hoses and rubber washe_ flom die
plastic bag and install the robber washe,_ in each end
of the inlet hoses.
3. (90 ° elbow end)
Careflflly connect the inlet
hose marked HOT to the ..
outside "H" outlet of the
water valve. Tighmn by
band, then tighten another
2/3 mrn with pliers.
Carefiflly connect the other
inlet hose to the inside "C"
outer of the water valve. Tighten by hand; then fighmn
another 2/3 mrn with pliers. Do not crossthread or
over-tighten these connections.
4. Connect file inlet hose ends to the HOT and COLD
water f_mcets tightly by hand, then tighten another 2/3
mrn with pliers. Turn the wamr on and check for leaks.
5.
6.
Careflflly move die washer to its final location. Gently
liR up on the flont of the washer and slide back.
NOTE: Do not use the dispenser drawer or door to lift
file washer
With the washer in its
final position, place a
level on top of the
washer (if the washer
is installed under a
counte_; the washer _ ._.7
should not be able to
rock). Adjust the flont
leveling legs up or
down to ensure the washer is resting solid. Turn the
lock nuts on each leg up towards the base of the
washer and snug with a wrench.
NOTE: Keep file leg extension at a minimum to
prevent excessive vibration. The fiutber out the
legs are exmnded, the more the washer will vibrato.
If file floor is not level or is damaged, you may have
to extend the rear leveling legs. For tmdercounmr
instaUations, you can adjust the rear legs by removing
the flont service panel.
15
To Next Page
Loading...
