Commissioning
First start
2018-9015-008
01. July 2018
45 / 162
5 Commissioning
5.1 Special Qualification
Initial commissioning must only be carried out by trained personnel in accordance
with the safety instructions.
See also the section on ”Personnel qualification”.
5.2 Safety Instructions
To prevent damage to property and/or life-threatening injury to personnel, always
observe the following:
● Do not operate this product until the initial commissioning checklist is
completed.
● Read the ”Safety” section as well.
5.3 First start
The first start steps intend to test the product in order to validate its functionality and
efficiency before handing it over to the customer. Therefore, the dealer along with
the customer must operate the product as well as the operating elements.
Initial commissioning checklist
This checklist must be completed by the dealer and the customer to validate that
the product is assembled and/or installed according to the manufacturer's
instructions and that it is safe for use.
To Next Page
