Safety Instructions
3
1 Safety Instructions
Safe operation of this device is only warranteed, if the instructions in this operating manual have
been complied with.
For installation: Always disconnect system power supplies!
Only use manufacturer's parts and accessories!
• The device may only be opened or repaired by
authorized personal. Never open the device or carry
out repairs yourself. Always contact an authorized
technical servicer. You can find all necessary service
information in the chapter "Service and Mainte-
nance".
• Before the device is turned on, make sure that the
system voltage of your installation matches the
supply voltage of the device. The device characte-
ristics are printed on the name plate and in the tech-
nical data.
- The name plate is located on the underside of the
device.
- For the technical data of the device, refer to the
chapter "Technical Data".
• The peripheral devices that are connected to the in-
terfaces and the DC circuits of this device have to
meet the requirements for safety extra-low voltage
(SELV) in accordance with EN/IEC 60950.
• Switching off the device does not completely dis-
connect it from the power supply. Your device is
only disconnected completely, when the power plug
is unplugged.
• Please make sure that the power supply cable is run
in a way that nobody trips over it, and it cannot be
damaged by other devices.
• During operation, surfaces in the surrounding area
of the print head may heat up. Therefore, direct con-
tact with the print head must be avoided to prevent
burning accidents.
Do not put heat sensitive objects close to this heat
source.
• Avoid constant high humidity and condensation.
Protect the device from being splashed and from
getting in contact with chemicals.
• Only use spare parts and accessories supplied or
authorized by GeBE. The use of unauthorized parts
or accessories may affect the function and safety of
the device. All parts included are listed in the chap-
ter "Packing List", while the original accessories are
listed in the chapter "Parts and Accessories ".
• It is no longer possible to safely operate the device, if:
- the housing has been damaged.
- moisture reached the inside of the device
- smoke is coming from the inside of the device
- the power supply cord is damaged
- the device stopped working properly.
Turn off the device immediately, when a failure occurs, as
mentioned above, and contact GeBE customer service.
See chapter "Service and Maintenance".
• We explicitly state that all product liability and guara-
tee claims are null and void, if the device has not been
used in accordance with the instructions in this opera-
ting manual or on the device itself!
• Risk of explosion in case of incorrect battery ex-
change.
• Please read how to safely exchange batteries in the
chapter "Exchanging Batteries".
• The printer versions with an infrared interface contain
a light emitting diode of laser category I. This infrared
transmitter does not pose a threat for the human eye
or skin, even with long periods of exposure.
• The device complies with laser category I in accordan-
ce with EN60825-1/A2:2001
• It is prohibited to operate the device, if the housing is
damaged. Please contact GeBE Service. You can find
the information under "Service and Maintenance". For
the description of the infrared interface, please refer to
page 8.
To Next Page
Loading...