EN
29
B971-003 © 06-2015
965.598.00.0 (02)
Cleaning and lubricating the Geberit pressing tool
Prerequisites
Rechargeable battery is not inserted in the pressing tool.
1 Push in both release buttons on the rechargeable battery and pull out the battery (see
cover page in the back, figure E).
2 Clean the roller drive and retaining pin of the pressing tool.
3 Use compressed air or a brush to remove dirt.
4 Use BRUNOX® Turbo-Spray® or equivalent to lubricate the roller drive, its guide and the
retaining pin (see cover page in the back, figure F).
5 Wipe off any excess lubricant.
WARNING
Risk of injury from switching on inadvertently
` Remove the rechargeable battery before starting any maintenance work on the
pressing tool
CAUTION
Damage to the device from dampness or moisture
` Never immerse the pressing tool in water or other liquids
To Next Page
Loading...
