9
Connection of main keypad
Note: always shut power down before connecting an accessory to the in�ye or the in�yt�
To connect the keypad, remove the cover, then insert the in�link connector into the appropriate keypad connector
(as illustrated)� Route the cable through one of the molded strain relief channels on the bottom right side of the spa
pack (as illustrated)� Fill the remaining space with the foam gaskets supplied� Don’t forget to replace the cover and all
screws (torque to 8 in� lb max (0�9 N�m))�
Keypad
Connect the
main keypad as
indicated here�
Connections
To Next Page
Loading...
Need help?
General
