38
OSDVPOS Command
The OSDVPOS command sets the vertical position of the OSD.
Syntax:
OSDVPOS param1
Parameters:
param1 VPos [0...100]
Notes:
Use ? for param1 to retrieve the current value.
POWER Command
The POWER command turns the Scaler ON or OFF.
Syntax:
OSDVPOS param1
Parameters:
param1 State
Value Meaning
Off Power Off
On Power On
TGL Toggle Power State
Notes:
Setting param1 to TGL will automatically toggle the current power state. This
provides a non-implicit form of turning the Scaler ON or OFF.
Use ? for param1 to retrieve the current value.
RS-232 SERIAL COMMANDS
To Next Page
Loading...