Need help?Do you have a question about the Gefen GTV-ETH-2-PLC and is the answer not in the manual?
Provides telephone numbers, fax, and support hours for technical assistance.
Includes mailing address and email for customer service inquiries.
Key notes before installing or operating the GefenTV Ethernet Over PLC.
Step-by-step guide for installing the GefenTV Configuration Assistant software.
Steps to connect source, devices, and power cables to sender and receiver units.
Details on Net ID, Encryption Key, Alias, and password settings for node configuration.
Steps to configure the local node using Net ID and encryption key from the remote node.
Explains Master Node, Slave Node, and the ASCM process for secure connections.
Step-by-step instructions to set up a secure network connection using ASCM.
Outlines the methods for updating firmware: FTP, TFTP, or direct file transfer.
To Next Page
General