34
80290C_MHW_2400_0908_ENG
C
[xrd]
Number of Alarms Enabled
[0 ... 10]
Peak Key Function
Function
0 Disabled (no function)
2 HOLD IN1
3 Reset memory latch
7 Set / Reset outputs OUT 1 ... OUT 4 (for but.1 only)
8 Peak ON + (maximum) IN1
9 Peak ON - (minimum) IN1
10 Peak ON - peak
(maximum peak - minimum peak) IN1
11 Reset memory peak IN1
12 Reset alarms / peak IN1
15 Check calibration strain-gauge IN1
(6-wire probe)
16 Calibrate strain-gauge IN1
17 U.CAL calibration (from version 1.44)
23 Zero tare IN1
24 Zero tare IN1 / Reset alarm latch
25 Zero tare IN1 / Reset peak latch IN1
26 Zero tare IN1 / Reset alarm latch /
Reset peak latch IN1
27 Display HOLD
28 FLASH IN1
29 Net / Gross IN1 (display of gross value is indicated
by the flashing decimal point of the ones)
CAL/RST Key Function
Key Function
D
+32 to refer to input IN2. (only for values on table referred
to IN1)
for but3 only, adding +64 to value shown in table, disable
“back menu” function (immediate exit from configuration
menus with key combination + ).
To Next Page
Loading...
