Machine Operation
Operating the Right Control Lever
WARNING
Be careful to check which pattern
of lever control arrangement you
are operating with before beginning
operations.
Make sure the bucket is lowered to
the ground before floating the lift
arms. Floating the lift arms while they
are raised will cause the bucket to fall
rapidly and is extremely dangerous.
Do not drive the loader forward with
the lift arms in Float position.
At times of combined operation of
bucket and lowering, tilting the lift
arms, continuation of the combined
operation after the bucket cylinder has
reached fall stroke will result in the lift
arms rising or stopping without going
lower. Be cautious of any unexpected
movement of the lift arms.
Use the right control lever to operate the lift
arms and bucket.
Return the right control lever to the neutral
position to stop the lift arms and bucket.
Set the safety bar to the released position.
Operating the Lift Arms
To lower the lift arms:
Push the right control lever forward.
To raise the lift arms:
Pull the right control lever rearward.
Operating the Bucket
To roll back:
Tilt the right control lever to the left.
To dump:
Tilt the right control lever to the right.
Operating the Lift Arms Float
To float the lift arms:
Press the float switch on the right control
lever.
To Next Page
Loading...