Service Data
* : If the percentage of the traveling time within the total operating time is high, replace the
gear oil earlier than the specified time.
** : For water, use tap water (soft). Do not use well or river water.
When the ambient temperature drops below 0°C, add coolant (antifreeze). Follow the
coolant manufacturer’s instructions to determine the mixture ratio.
Fuel
Diesel Fuel Specifications
Diesel fuel should comply with the following specifications. The table lists several worldwide
specifications for diesel fuels.
Part
Capacity L
(US gal.)
Type
CTL55: 57
(15.1 US gal.)
CTL65: 75
(19.8 US gal.)
CTL75: 90
(23.8 US gal.)
CTL85: 108
(28.5 US gal.)
Fuel tank Diesel fuel
Use a clean, quality fuel for good performance and
optimum engine life.
To prevent fuel flow problems in cold weather,
use diesel fuel with a pour point of at least –
12°C (10°F) below the lowest expected ambient
temperature.
Minimum cetane number is 45. Low
temperature or high altitude operation may
require the use of fuel with a higher cetane
number.
Use fuel with sulfur content of less than 0.05%
by volume.
A higher sulfur content fuel may cause sulfuric
acid corrosion in the cylinders of the engines.
NEVER mix kerosene, used engine oil, or
residual fuels with the diesel fuel.
Poor quality fuel can reduce engine
performance and / or cause engine damage.
Fuel additives are not recommended. Some fuel
additives may cause poor engine performance.
ASTM D975
No.1D S15, S500
No.2D S15, S500
Diesel Fuel Specification Diesel Fuel SpecificationLocation Location
USA
European
Union
EN590:96
ISO 8217 DMX
BS 2869-A1 or A2
International
United
Kingdom
To Next Page
Loading...
Need help?
General
