After First 50 Hours (New Machines Only)
10. Clean the filter installation surface on the
filter stand.
11. Apply a thin layer of oil to the packing of
the new filter.
12. Install the new filter by hand.
13. Tighten one more turn after the filter
packing comes in contact with the
surface.
14. Supply oil up to the upper limit (H) of the
dipstick (1). Problems could arise if the
oil level is either too low or too high.
15. Tighten the oil supply cap (2).
16. Lower the ROPS.
17. Start the engine, run it at low idle for
about 3 minutes, then stop it.
18. After about 10 minutes, inspect the oil
level.
To Next Page
Loading...