MAINTENANCE
126
After First 50 Hours (New Machines Only)
Replacing the Pilot Line Filter
WARNING
Stop the engine and allow the
machine to cool before performing
maintenance.
Oil may spray out if caps or filters are
removed or pipes disconnected before
releasing the pressure in the hydraulic
system.
• When removing plugs or screws or
disconnecting hoses, stand to the
side and loosen slowly, to gradually
release the internal pressure before
removing.
1. Tilt up the ROPS.
Refer to page 151, “Tilting Up the
ROPS.”
2. Turn the case (1) counterclockwise and
remove it.
3. Remove the element (2) and O-ring (3).
4. Clean the inside of the case (1).
5. Install the new element in the case (1).
6. Install the new O-ring, then tighten the
case (1).
To Next Page
Loading...