Doors and Covers
Disengagement
1. Align the hook (4) on the tip of the locking
pin (1) with the locking pin.
2. Pull out the locking pin (1) from the lift arm
stop (2).
3. Hook the end part of the spring (3) onto
the hook (5) of the lift arm stop (2).
4. Sit in the seat, fasten the seat belt, start
the engine and lower the safety bar.
5. Raise the lift arms slowly until the spring
(3) will lift the lift arm stop (2) off the cylinder
rod.
6. Lower the lift arms slowly to the ground
and stop the engine.
7. Raise the lift arm stop (2) into storage
position and insert the locking pin (1)
through lift arm stop and bracket.
8. To prevent the locking pin (1) from falling
off, set the hook (4) at a right angle to the
locking pin.
Fuel Filler Cap
WARNING
Do not smoke or permit open
flames while fueling or near fueling
operations.
Supply fuel in a well ventilated place
and with the engine stopped.
Clean up spilled fuel immediately.
Do not fill the fuel tank to capacity.
Allow room for expansion.
Tighten the fuel filler cap securely.
Opening
1. Open the key cover, insert the key and
turn it counterclockwise to unlock the fuel
cap.
2. Turn the fuel cap counterclockwise and
remove it.
Closing
1. Set the fuel cap in place and turn it
clockwise.
2. Turn the key clockwise to lock the fuel
cap, then remove the key.
To Next Page
Loading...