Gehl CTL85 User Manual

CONTROLS
58
Travel Speed Button
Press this button to set the travel speed to
2nd speed (high speed) while travel speed
lamp lights. Press again to return to 1st
speed (low speed) and travel speed lamp
turns off.
Travel speed always begins in 1st speed
when starting the engine.
Refer to page 53, “Travel Speed Lamp.”
Light Switches
When this switch is turned on while the
ignition switch is ON, the lights turn on as
follows:
Front light switch
O ............... Off
I ................Instrument lights and front lights
turn on.
Tail light switch
O ............... Off
I ................Tail lights turn on.
Wiper Switches (Option)
IMPORTANT: If no washer fluid is
discharged, do not operate the washer.
Doing so may damage the pump.
IMPORTANT: Operating the wiper with no
moisture on the windshield will scratch
the glass. Apply water or washer fluid
when operating the wiper.
IMPORTANT: In cold seasons, the wiper
blade may freeze to the glass. Operating
the wiper forcibly may damage the wiper
motor.
Front wiper switch
O ............... Off
I ................Wiper operates.
PUSH ....... Washer fluid is squirted from the
nozzle while pressed, and stops
when released.
Rear wiper switch
O ............... Off
I ................Wiper operates.
PUSH ....... Washer fluid is squirted from the
nozzle while pressed, and stops
when released.
Switches
L3B028
L3B029
PUSH

Gehl CTL85 Specifications

General

Brand	Gehl
Model	CTL85
Category	Tractor
Language	English