Backfilling
With the bucket lowered, drive near the hole and tilt the front edge of the bucket downward
as soon as it passes over the near side of the hole. Raise the bucket and empty the load only
when necessary.
Leveling Operation using the Float position
WARNING
Make sure the bucket is lowered to the ground before floating the lift arms. Floating the
lift arms while they are raised will cause the bucket to fall rapidly and is dangerous.
Do not drive the loader forward with the lift arms in Float position.
Lower the bucket onto the ground, then put the lift arms in Float position. Tilt the bucket
forward to stand it on its cutting edge, then level the loose material while driving rearward.
Loading
Approach the truck and stop, then raise the bucket until its lower edge clears the truck bed.
Drive the loader slowly forward, stop at the position where the bucket is to be tilted forward,
then tilt the bucket forward, releasing the material in the bucket into the truck bed. When the
truck is half loaded, use the bucket to spread the load evenly.
Operating Procedures
To Next Page
Loading...
Need help?
General
