Gehl HL 360 User Manual

Scraping with a Bucket (Figs. 13 & 14)
Both HL360 Skid Steer Loader models, units with either
2-Spool
or 3-Spool Control Valves, can be used for
scraping with a Bucket attached
to the Load Arms. For
scraping, the Loader should be operated in the forward
direction. First position the
Load Arms at the
appropriate level which allows the Bucket
to be tipped to
place the Bucket Cutting Edge
at a slight angle to the
surface being scraped. While traveling forward with the
Bucket in this position, material can flow over the
Cutting Edge
and collect inside the Bucket.
.~. --- .. - _._. ----- ---_ ........ --- ---_ .. -- -- -- - -- -- - .......
... \
·
·
•
·
·
·
•
·
·
·
·
·
•
·
·
·
· ·
·
· .
·
·
, """""",
'
'
.
.
,
\
· .
\' .
· .
: .~\\: ~ l" ' L'~ ~ : ' , "~<~ ,: ~T ~ '::~ :
: ~ :
,,\H '- ;:\ ~ )~ ,Y ,,'" ~ "l " ~ ,. "" ,,
: \.,' . \: 1,~,1,'v n .'l \ "'~:
: ~:
: ~''''''''''''~ :
: \.~,:
: ~ : '~'~':~: ~\ ,',~ ~ ' ~ \
: ~,~:
:
•
~ ~,\: : : :~ ~ ~',:~ " I" ~
: ~~,:
· .
·
: ~"_\:~:~ ~ ·:u~ :
\':: ' ~'.~~ -:
1.._ ------------------------ -,
Fig.13
.................. _--_ .......... .. ......... .... .. .
\
~ ,' .. ' ,' ." S
\ \" . . ,\,,,- , .,,~ \
l _ ___ ___ __ . __ . _____ . __ ..... .l
\, ' ;' :~ ..... '
Fig.14
Leveling with a Bucket (Fig. 15)
NOT . E: Levelin~ with a Bucket attached to the
•
Load Arms
is best accomplished with a Loader
equipped with the Float "detent" feature, that is, an
HL360 with 3-Spool Control Valve and Auxiliary
Hydraulics.
First drive the Loader to the outer edge of the area to be
levelled. Then, with the Load Arms down against the
Frame, push the Lift / Tilt T-bar into the Float position
and roll the Bucket forward to place the Bucket Cutting
Edge
at a 30 to 45 ° angle to the surface to be levelled.
Proceed to level the area
by driving the Loader
backward.
17

Gehl HL 360 Specifications

General

Brand	Gehl
Model	HL 360
Category	Front End Loaders
Language	English