GEL DECAL BASIC - Water Softener Components

26
COMPONENTS OF THE WATER SOFTENER
The softener is the absolute solution to scale problems in water. Very easy to install and to use, it is made
up of a container for the resins, a container for the salt, necessary for periodically regenerating the resins,
and a hydropneumatic valve which, controlled by a timer, carries out the regeneration cycles necessary to
keep the unit efficient.
IMPORTANT: the softener may be installed on municipal water only. For different applications
(on well water, etc.) please ask GEL Export Department by e-mail (export@gel.it) for the written
authorisation indicating the serial number of the softener.
1 - Timer
2 - Valve
3 - Vessels with resins
4 - Cabinet (resins container, salt tank)
5 - Plug
6 - Trap
7 - Brine valve
8 - Mixing valve
9 - Chlorine cell
10 - Brine suction hose
11 - Drain hose
12 - Drain
13 - Vessel base
Note: in Decal models the brine tank is separated
from the valve/ timer group.
INSPECTION
Upon receipt of the water softener:
• Check that the packaging and the softener itself have not been damaged during transport
• Check that the carton contains the following components:
Decal Basic Models:
• Group vessel-valve-timer;
• brine tank, fitted with trap and brine valve;
• reinforced hose;
• brine suction hose;
• hardness kit;
• instruction manual.
Decalux Basic Models:
• Group cabinet-vessel-valve-timer;
• brine suction hose;
• hardness kit;
• instruction manual.