Need help?Do you have a question about the GEL DECAL BASIC and is the answer not in the manual?
General| Brand | GEL |
|---|---|
| Model | DECAL BASIC |
| Category | Water Dispenser |
| Language | English |
Ensures installation by qualified staff, following drawings and regulations.
Specifies pressure, temperature, and voltage requirements for installation.
Instructions for connecting brine suction hose, drain, and overflow hoses.
Covers installation check, hardness measurement, timer programming, and manual regeneration.
Introduction to the GEL timers for automatic softener control and programming.
Explains regeneration modes: Time, Volume, Volume/Time.
Steps to adjust water hardness using the timer's interface.
Procedure to set the regeneration time, advising night-time use.
Procedure to set the regeneration frequency in days, recommending 4 days for potable use.
Guide to selecting regeneration priority: Time, Volume, or Volume/Time.
Instructions on how to start a manual regeneration cycle using the timer.
Diagnoses and solutions for softener not regenerating or supplying soft water.
Diagnoses and solutions for brine sucking, salt usage, and valve leaking problems.
To Next Page
