NOTE
There are many things that can affect a vehicle’s range on a charge: driving
style, terrain, increased vehicle payloads, cab heater usage and other
electrical accessory usage. Even though things like these can decrease a
vehicle’s range, they should be accounted for in the state of charge reading. If
you are working on a MY16-18 core GEM vehicle, and suspect that the cab
heater’s usage is not being accounted for in the state of charge, reference
Team Tip L-18-04-02.
INFORMATION DISPLAY MODE
This area will display clock, odometer, trip meter, state of charge (SOC), range
meter, efficiency rate (EFF) or any existing fault codes or warning messages.
The display can be changed to show either standard or metric units of
measurement for each of the following settings.
Standard Display Metric Display
Distance Miles Kilometers
Temperature Fahrenheit Celsius
Time 12-Hour Clock 24-Hour Clock
1. Turn the key to the OFF position.
2. Press and hold the MODE button while turning the key to the ON position.
3. When the display flashes the distance setting, tap the MODE button to
advance to the desired setting.
4. Press and hold the MODE button to save the setting and advance to the next
display option.
5. Repeat the procedure to change remaining display settings.
TIP
To exit the set-up mode, turn the key off. Wait 5 seconds, then turn the key on.
The gauge displays the mode that was displayed prior to setting the units.
CLOCK RESETTING
TIP
The clock must be reset any time the batteries have been disconnected or fully
discharged.
31
FEATURES AND CONTROLS
To Next Page
Loading...
