*CLEANING MINERAL DEPOSITS (COFFEE AND
HOT WATER PART)
1. The use of cleaning agents and amount is same with steam part;
2. Lock the filter holder (no coffee powder) into group head. According to
part “B” MAKE ESPRESSO COFFEE’’;
3. Press auto coffee (large) button to make coffee, it will automatic stop after
finished;
4. Press hot water button to make hot water, it will automatic stop after
finished;
5. Make descales deposit in the machine at least 15min;
6. Press coffee and hot water button again to make coffee and hot water until
all descaling agent outflow (image 13);
7. Clean the water tank with pure water;
8. Use soft water or pure water (no coffee powder) to clean again, repeat
steps three times to make sure the pipe has been cleaned;
Note: Is there remaining coffee powder on the edge of filter, will be
easy to cause sealing adversely and water leakage.
3. Turn off hot water button after the desired water is reached (The default
automatic stop time is 5 seconds);
Note: Do not touch the hot water immediately after making hot water.
Be careful not to be scald.
*MAKING STEAM/ FROTHING MILK
1. Prepare a cup of espresso first according to part B. “MAKE ESPRESSO
COFFEE’’;
2. Use whole, fresh cold milk out of fridge (8-10℃), and pour 1/3 milk in the
cup;
Note: Use a stainless steel cup, and cup diameter should not less than
70 ± 5mm, due to the volume of milk will increase after frothing.
3. Put steam nozzle into cup, under milk 1cm;
4. Rotate to open the steam knob, steam will eject from steam pipe (image
10);
5. Remove cup when desired milk foam reached, then reverse rotation knob
to turn off , steam is stopped, pour the frothed milk into prepared espresso,
now cappuccino is ready, you can add some sugar or coco powder if you
like it.
Note: Purge steam to clean steam nozzle immediately after use, to
prevent milk scaling. Caution high temperature of steam nozzle when
in use, do not touch to avoid scald. Please hold the black soft part to
move the steam pipe. (Image 11)
*TURN OFF MACHINE.
1. At any time turn off main power button to turn off the machine.
2. Please turn off external power supply when you don’t use the machine;
3. Please pour out the water from water tank if the machine will not use for
long time or need to transport. (See Section 6.4 Steam Cleaning
Operation)
To Next Page
Loading...
