30
GLOSSARY
Exit/Entry Delays: Separate
delays that let you exit and
enter your premises without
setting off an alarm when the
system is armed.
INTERIOR Button: Bypasses
Interior Zones on arming (see
Zones - Interior Zones).
Instant Protection: Arming
without entry delay using the
F button while remaining
on the premises.
Keypad: Puts control-panel
functions at your fingertips. It
can be mounted anywhere in
your premises.
Manager's Mode: In a partitioned
system, a low-security
operating mode that allows
arming by area.
Panic Buttons: Blue buttons on
the keypad (G and 7,
8 or 9). If enabled,
pressing G together with
7, 8 or 9 will alert
the central station of a fire,
auxiliary, or police emergency.
Partitioned System: A system
that has been subdivided into
two or more (up to eight)
independent subsystems
(areas).
Pre-Alarm Warning: A keypad
sounder alert of an impending
alarm. This option is
programmable by zone for the
same duration as that
programmed for Abort Delay
(see Abort Delay).
Report: A transmission to a
central station notifying of a
change in the status of the
system (alarm, trouble, low
battery, etc.).
RF Low Battery: (Wireless sys-
tems only) Weak transmitter
battery.
F Check In: (Wireless systems
only) Periodic test report from
transmitter (if a report is not
received on time, a
supervisory-failure system
trouble will result).
Ringback: A beep after arming
verifying the central-station's
receipt of a closing report.
Service Code: A code intended
for temporary use.
Sounder - A local warning device
at each keypad to alert that (a)
entry delay has started; (b) an
attempt was made to arm with
a zone in trouble; (c) a Day-
Zone condition exists (see
Zones: Day Zone); (d) 10
seconds exit time remaining;
(e) invalid code entered; or (f)
central station acknowledged
arming (see Ringback).
To Next Page
Loading...
