iKEY PORTABLE USB RECORDER
INTRODUCTION:
Congratulations on purchasing a G
EMINI
iKEY PORTABLE USB RECORDER
. This state
of-the-art recording device features the latest technology and is backed by a ONE year
limited warranty*. Prior to use, we suggest that you carefully read all the instruc-
tions.
FEATURES:
- USB Port (For direct connectivity to supported USB Storage Device)
- Compatible with USB 2.0/1.1/1.0 devices
- Records audio to Uncompressed WAV format or MP3 format (w/ selectable bit rate,
up to 256kbps)
- Gold plated RCA inputs
- LED Indicator shows memory remaining on target drive
- Battery powered w/ low battery indicator
- DC charger input for use with rechargeable batteries
- Level clip indicator
- Record volume control
- Reset button
- DC adapter included
- Battery powered (with the use of 4 ‘AA’ batteries; not included)
CAUTIONS:
1. Read all operating instructions before using this equipment.
2. To reduce the risk of electrical shock, do not open the unit. There are N
O USER
REPLACEABLE PARTS INSIDE. Please contact the GEMINI SERVICE DEPARTMENT or your
authorized dealer to speak to a qualified GEMINI SOUND PRODUCTS technician.
3. In the USA: If you experience problems with this unit, please visit
HTTP://WWW.GEM-
INIDJ
.COM/SUPPORT.HTML
or call 1 (732) 738-9003 for G
EMINI CUSTOMER SERVICE
. Do
not attempt to return this equipment to your dealer.
4. Be sure to allow adequate ventilation to avoid possible heat damage to your
equipment.
5. D
O NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. Operators of electronic equip-
ment should in no way be in contact with water.
6. D
O NOT USE ANY SPRAY CLEANER OR LUBRICANT ON ANY CONTROLS OR SWITCHES.
QUICK START INSTRUCTIONS:
1. After installing batteries or connecting the DC A
DAPTOR (2), turn the POWER
SWITCH (3) ON.
2. Connect your USB mass storage device to the USB P
ORT (5). Once the storage
device is initialized, the P
ROGRESS LEDS (11) will flash six times indicating how much
storage is occupied on the connected device.
3. Connect a line-level audio signal to the RCA L
INE IN
(6) jacks. Adjust the L
EVEL
(7) control until the LEVEL CLIP (10) LED stays unlit.
4. Press the S
ELECTOR
(9) button to set the desired B
IT RATE
at which you would like
to record. You may also choose uncompressed WAV format.
5. Press the R
ECORD (8) button to start and stop your recording. Each time the
RECORD (8) button is pressed, all of the progress LEDs will flash once to indicate that
the unit has understood your command.
6. When you are finished recording, press and hold the R
ECORD (8) button until all
of LED lights flash 3 times consecutively. You may now remove the connected USB
storage device.
NOTE: I
F YOU PLAN TO RECORD TO AN
iPod®, PLEASE BE SURE TO READ THE SECTION ENTI-
TLED “iPod® OPERATION NOTES.” BEFORE PROCEEDING!
BATTERY INSTALLATION:
1. Make sure the P
OWER SWITCH (3) is set to OFF before plugging in the unit to an
electrical outlet.
2. Behind the iKEY’s aluminum faceplate is a battery compartment for four AA bat-
teries to power the unit. To access the battery compartment, unscrew the four
screws that are found on the corners of the aluminum faceplate. In the event that
you need quick access to the battery compartment, you may use the four thumb
<4>
To Next Page
Loading...
Need help?
General
