mdj-600 manual • geminisound.com
6
POWER
Plug the 2 prong power cable into the power input on the back of the MDJ-600 (A), and the other end into Mains power.
LINE OUTPUT
Plug one end of the included RCA cable into the LINE OUTPUT JACK (D) on the rear panel.
Plug the other end of the RCA connectors into any available line input jacks on your mixer.
If you are connecting the MDJ-600 through a receiver, you can plug the RCA connectors into the CD AUX INPUT JACKS
on your receiver. If there are no CD or AUX INPUTS use any line level (not phono) inputs.
USB
Plug in the USB cable into the USB OUT (B) on the rear panel. Plug the other end of the USB cable into any available
USB port on your computer. This will enable you to use the MDJ-600 in MIDI mode.
CONNECTING THE MDJ-600
To Next Page
Loading...
