To Next PageTo Next Page
Need help?Do you have a question about the Gemini SA-600 and is the answer not in the manual?
General| S/N Ratio | > 50dB |
|---|---|
| Platter | Aluminum Die-cast |
| Start/Stop | Yes |
| Speeds | 33, 45 RPM |
| Braking System | Electronic Braking |
| Tonearm Type | Static Balance S-Type |
| Output | RCA |
| Power Supply | 110-220V, 50/60Hz |
Steps to place and stabilize the turntable unit on a flat, level surface free of vibration.
Guide on connecting lead wires to cartridge terminals and mounting it in the headshell.
Instructions for inserting and locking the headshell into the tubular tonearm.
Advice on needle types for straight tonearms and stylus alignment for proper playback.
Steps to slide and screw the counterweight onto the rear of the tonearm.
Guide to balance the tonearm horizontally and set the correct stylus pressure.
Guidance on setting the anti-skating control to match the stylus pressure.
Steps for mounting the dustcover hinges and sliding them into the rear panel holders.
Instructions for connecting the AC power plug and output RCA plugs to a mixer or receiver.
Steps for placing a record, selecting speed, starting playback, and stopping the turntable.
How to lift and lower the tonearm to pause and resume playback.
Instructions for playing 45 RPM records, including using the 45 adapter.
How to use and turn off the target light to illuminate the stylus tip.
Explanation of how the pitch control adjusts playback speed by +/- 10%.
How to temporarily raise or lower pitch using dedicated buttons without changing slide setting.
