To Next PageTo Next PageWhy is my Gemmy Laboratory Equipment vibrating?
Vibration in your Gemmy Laboratory Equipment can occur due to a rotor imbalance. Make sure to place tubes symmetrically. Another possible cause is a defective rubber support; in this case, replace it with a new one.
What to do if Gemmy PLC-02 failure of operation?
If your Gemmy Laboratory Equipment fails to operate, it could be due to several reasons. Worn-out brushes might be the cause, so replace the carbon brushes. Alternatively, the motor or PCB could be defective, requiring replacement of those parts. Also check for a blown fuse and replace it if necessary. Finally, ensure the linkage is connected; if disengaged, connect it.
Why is my Gemmy Laboratory Equipment speed erratic?
Erratic speed in your Gemmy Laboratory Equipment may be caused by worn-out carbon brushes; replace them with new ones. Another possibility is a defective triac or VR, which would require replacing those parts.
What to do if Gemmy PLC-02 motor spinning failure?
If the motor in your Gemmy Laboratory Equipment fails to spin, several factors could be responsible. First, check the carbon brushes for wear and replace them if needed. Second, the PCB might be malfunctioning, requiring replacement. Third, the motor itself could be burnt out, necessitating replacement. Finally, ensure all wiring is properly connected; reconnect any disengaged wiring.
General| Brand | Gemmy |
|---|---|
| Model | PLC-02 |
| Category | Laboratory Equipment |
| Language | English |
