EasyManua.ls Logo

Gemsy 7724 - Page 24

Default Icon
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4.Trouble Shooting
Phenomena
Possible cause
Remedy
④Foot groove not match
the needle
⑤Thread not through in
the correct way
⑥Needle not properly
fixed
Adjust the foot groove to match needle
Through in the correct way
Make sure needle groove point to the operator
Poor thread
tightening
①Differential ratio too
small
②The bottom of foot is not
paralleled to the feed dog
③The pressure of foot is
too heavy or too light
Increase differential ratio till the material flat
Parallel them
Adjust the pressure
1locked
respectively of
the layer
①Pressure of the foot too
much or not flat
Increase the pressure
②Resistance of foot too
much or not flat
Polish the foot or make it flat
③Feet dogs are not
parallel
②Knife blunt
Change the height of feet dog to make them parallel
Make knife sharp or replaced
Stitch is not
equably
①Thread through in wrong
way
②Thread bracket fixed in
wrong way
Make the thread through in the correct way
Adjust the thread bracket make thread pass easily
③Knife bottom fixed in the
wrong way
④Trimmer edge out of
order
Adjust the knife bottom
Skive lower knife or change upper knife
Noise
⑤Hole for thread broken
⑥Needle point broken
⑦Feeding device not in
the right height
①Parts loosen and collide
with each other
Polish the hole edge
Change to a new one
Adjust the height
Check the machine comprehensively then tighten all the loosen
parts
③Needle bracket is not
fixed in the right place
Adjust the needle bracket make thread 0.1mm away from needle
guide
④Knife can't cut
immediately
⑤Needle too big
Make it sharp or change a new one
Make needle match material
②Lubrication system
blocked
Clear the pump make oil get through fluently
⑥Width of locked part
less than needle plate
Change the width or replace the needle plate
Trimmer edge
not orderly
①Knife fixed wrong
Make the knife in the right position
⑧Pressure of foot too
heavy or light
Adjust the pressure
③Rubber mat out of palce
Make sure the mat put in the right place without noise uttered
①Oil prevent plate of feed
dog
Replace the broken part and tight the screw
Oil leak
15