Generac Power Systems 1042-1 User Manual

Generac 2250PSI High Pressure Washer
AASSSSEEMMBBLLYY
GENERAC
6
High Pressure Washer
 Insert the carriage bolts through the aligned holes
on the handle and attach the plastic knobs. Tighten
the knobs by hand (Figure 2).
 Insert the wire support with the longer arm positioned
on the left. From this view (from rear of unit) the hook
should resemble a J (Figure 3).
Add Engine Oil
IMPORTANT: Any attempt to crank or start the
engine before it has been properly serviced with the
recommended oil may result in an engine failure.
Note: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF,SG, SH or rated SAE 30 weight.
Select the oils viscosity grade according to your
expected operating temperature. Do Not Use SAE
10W40 Oil. Do not use the upper grey oil fill cap.
Although multi-viscosity oils (5W30, 10W30, etc.)
improve starting in cold weather, these multi-viscosity
oils will result in increased oil consumption when used
above 32°F. Check your engine oil level more
frequently to avoid possible damage from running
low on oil.
 Place pressure washer on a level surface.
 Clean area around oil fill and remove yellow oil fill
cap (Figure 4). Do not use the upper grey oil fill
cap.
 Fill with recommended oil. Oil should be full to
overflowing. (Approximately 21 ounces).
 Install oil fill cap, tighten securely.
Note: Check Oil Often During Engine Breakin.
Add Gasoline
DANGER! Never fill fuel tank indoors.
Never fill fuel tank when engine is run-
ning or hot. Do not smoke when filling
fuel tank.
WARNING! Never fill fuel tank com-
pletely full. Fill tank to about 1/2" below
the bottom of the filler neck to provide
space for fuel expansion. Wipe away any
fuel spillage from engine and equipment
before starting.
DO NOT operate or refuel engine with
spark plug access hole cover removed.
Allow engine to cool 2 minutes before
refueling.
Figure 3 — Fit wire form on handle.
Figure 4 — Add oil to engine crankcase. Do not
attempt to start engine without
adding oil.
Yellow Oil
Fill Cap
Figure 2 — Insert the carriage bolt and hook
and attach the knobs.
colder 32°F warmer
5W30 SAE 30

Generac Power Systems 1042-1 Specifications

General

Brand	Generac Power Systems
Model	1042-1
Category	Pressure Washer
Language	English