SAFETY
Throughout this publication, DANGER, WARNING, and CAUTION
blocks are used to alert the mechanic to special instructions
concerning a particular service or operation that might be
hazardous if performed incorrectly or carelessly. Observe them
carefully. Their definitions are as follows:
After this heading, read instructions that, if not strictly complied
with, will result in serious personal injury, including death.
After this heading, read instructions that, if not strictly complied
with, could result in serious personal injury, including death.
After this heading, read instructions that, if not strictly complied
with, might result in minor or moderate injury.
Four commonly used safety symbols accompany the DANGER,
WARNING and CAUTION blocks. The type of information each
indicates follows:
This symbol points out important safety information that,
if not followed, could endanger personal safety and/or
property of others.
This symbol points out potential explosion hazard.
This symbol points out potential fire hazard.
This symbol points out potential electrical shock hazard.
These “Safety Alerts” alone cannot eliminate the hazards that
they signal. Strict compliance with these special instructions
plus “common sense” are major accident prevention measures.
READ THIS MANUAL THOROUGHLY
This SERVICE MANUAL has been written and published by
Generac to aid our dealers' technicians and company service
personnel when servicing the products described herein.
It is assumed that these personnel are familiar with the servicing
procedures for these products, or like or similar products
manufactured and marketed by Generac, and that they have
been trained in the recommended servicing procedures for these
products, including the use of common hand tools and any
special Generac tools or tools from other suppliers.
Generac could not possibly know of and advise the service
trade of all conceivable procedures by which a service might
be performed and of the possible hazards and/or results
of each method. We have not undertaken any such wide
evaluation. Therefore, anyone who uses a procedure or tool
not recommended by Generac must first satisfy themselves that
neither his nor the products safety will be endangered by the
service procedure selected.
All information, illustrations and specifications in this manual
are based on the latest product information available at the time
of publication.
When working on these products, remember that the electrical
system and engine ignition system are capable of violent and
damaging short circuits or severe electrical shocks. If you
intend to perform work where electrical terminals could be
grounded or touched, the battery cables should be disconnected
at the battery.
Any time the intake or exhaust openings of the engine are
exposed during service, they should be covered to prevent
accidental entry of foreign material. Entry of such materials will
result in extensive damage when the engine Is started.
During any maintenance procedure, replacement fasteners must
have the same measurements and strength as the fasteners
that were removed. Metric bolts and nuts have numbers
that indicate their strength. Customary bolts use radial lines
to indicate strength while most customary nuts do not have
strength markings. Mismatched or incorrect fasteners can
cause damage, malfunction and possible injury.
Note: Special Notes appear in bold type throughout this
publication. While not pertaining to safety, they emphasize
procedures, circumstances or specifications that require
special attention.
REPLACEMENT PARTS
When servicing this equipment, it is extremely important that all
components be properly installed and tightened. If improperly
installed and tightened, sparks could ignite fuel vapors from fuel
system leaks.
Foreword
Some of the terminology used in this manual may appear differently
for product manufactured by the factory and branded under another
label.
Generac Name Honeywell Name
TruePower Technology PrecisionPower Technology
Generac OHVI engine Generac OHVI Engine
Rhinocoat Rhinocoat
QuietTest WhisperCheck
Nexus Controller Sync Controller
Nexus Smart Switches Sync Transfer Switches with Load
Shedding Capability
Nexus Wireless Remote
Monitors
Sync Wireless Remote Monitors
Nexus Smart Switches Sync Smart Switches
To Next Page
Loading...
Need help?
General
