13-6
SECTION 13: ENGINE ASSEMBLY
b. Torque M6 screws to 4.5 Nm (40 in. lbs.).
c. Connect ignition ground wire to ignition ground terminal in
backing plate (see Figure 13-19).
d. Connect all remaining wires to their proper locations.
GROUND TERMINAL
Figure 13-19. Ground Terminal
2. Assemble governor lever to governor arm. DO NOT tighten at this
time.
3. Install speed adjust assembly (refer to Section 4).
a. Torque screws to 6.0 Nm (53 in. lbs.).
4. Install exhaust.
a. Torque screws to 19 Nm (168 in. lbs.).
5. Install fan and retaining ring.
a. Torque screws to 21.7 Nm (192 in. lbs.).
6. Install blower housing.
a. Torque screws to 4.5 Nm (40 in. lbs.).
7. Install rotating screen.
a. Torque screws to 1.9 Nm (17 in. lbs.).
8. Install intake manifold assembly.
a. Torque bolts to 19 Nm (168 in. lbs.).
9. Install finger guard.
a. Tighten screws by hand to approximately 1.3 Nm (12 in-lbs).
10. Connect governor linkage and speed control linkage (refer to
Section 4).
11. Install spark plugs.
a. Torque spark plugs to 19 Nm (168 in. lbs.).
ADJUST GOVERNOR
Note: Refer to Section 4, Page 4-3 for Static Governor Adjustment.
*
WARNING: BEFORE STARTING OR RUNNING ENGINE, static
adjustment of the governor must be completed! Failure to
make the static adjustments first could result in engine
overspeeding which may result in engine damage, property
damage or personal injury.
To Next Page
Loading...
Need help?
General
