Generac Power Systems H-100 User Manual

Table of Contents
H-100 Control Panel Technical Manual
1
Table of Contents
Safety Rules ........................................ Inside Front Cover
General Information ......................................................... 2
Introduction .................................................................... 2
Features .......................................................................... 2
Panel Setup ..................................................................... 2
Changing the Controller Configuration ........................ 2
Customization .............................................................. 2
The Measurement “Engine” ............................................. 3
Analog Channels .......................................................... 3
Analog Maths ............................................................... 3
Analog Alarms ............................................................. 4
Other Analog Options .................................................. 5
Analog Sensor Ratings ................................................. 5
Output Functions ............................................................ 5
Spare Analog Channels ................................................ 5
Engine Management ........................................................ 6
Generator Parameters .................................................. 6
Engine Settings ............................................................ 6
Starting and Stopping - Sequence Diagrams ................... 7
Voltage Regulator (Option) ..............................................8
Governor (Speed Regulator) Option ................................ 8
Trending .........................................................................9
Remote Trending ......................................................... 9
Local Trending ...........................................................10
GenLink Local Trending Setup .................................. 10
Trigger/Collection Type ..............................................13
The ILC .........................................................................10
The Front Panel Display ................................................ 11
Left Display ................................................................ 11
Right Display .............................................................11
Left Display Pages ...................................................... 11
Right Display Pages .................................................... 13
Alarms ....................................................................... 13
Engine ........................................................................... 14
Status ............................................................................ 16
Service .......................................................................... 17
Generator ...................................................................... 18
Diagnostics .................................................................... 19
Exercise/HTS ................................................................ 21
The Control Panel ......................................................... 23
The Alarm Log .............................................................. 23
The Event Log ............................................................... 23
Maintenance Settings .................................................... 24
Air/Fuel Ratio Control (Option) ..................................... 24
I
2
T Current Monitoring (Option) ................................... 24
Internal Exercise Function ............................................ 25
QuietTest
®
Setup Using GenLink .................................. 25
Normal Exercise Setup Using GenLink ......................... 26
QuietTest
®
Setup Using Front Panel .............................. 27
Set Date and Time ........................................................ 33
Date and Time Setup Using GenLink ......................... 33
Date and Time Setup Using Front Panel .................... 33
Adjust Display Contrast ................................................34
Enable Generac Commercial Transfer Switch (HTS) .... 35
HTS Setup Using GenLink ......................................... 35
HTS Setup Using Front Panel .................................... 35
Communications ........................................................... 37
Remote Annunciator Connection (Option) ..................... 37
New Generation GenLink (NGG) ................................... 37
GenLink Relay Control .............................................. 37
Set Engine Hours ....................................................... 37
Absolute Maximum Ratings ....................................... 37
Environmental Ratings .............................................. 37
Appendix ............................................................................38
Appendix A — Analog Functions ................................... 38
Appendix B — H-100 General I/O and Connector
Information ........................................... 40
H-100 Analog Inputs .................................................. 40
H-100 Digital Outputs ................................................ 41
H-100 Digital Inputs .................................................. 41
H-100 Digital Output Functions .................................42
H-100 Connector Pin Descriptions ............................ 46
Appendix C — Miscellaneous H-100
Internal Alsrms/Warnings ...................... 47
Notes ................................................................................... 48
AUTHORIZED SERVICE
DEALER LOCATION
To locate the nearest AUTHORIZED SERVICE
DEALER, please call this number:
1-800-333-1322
DEALER LOCATION INFORMATION
CAN BE OBTAINED AT THIS NUMBER,
or visit the website at www.generac.com.

Generac Power Systems H-100 Specifications

General

Brand	Generac Power Systems
Model	H-100
Category	Control Panel
Language	English