Press the “ENTER” button to exit edit mode.
Move the cursor to the on the bottom line.
Press the “ENTER” button to move to the second
page.
Move the cursor to the “QuietTest Selected” field on
the first line.
Press the “ENTER” button to enter edit mode.
Use the up and down arrow key until a “N” appears.
Press the “ENTER” button to exit edit mode.
Setup of Normal Exercise is now complete. For this
example, exercise will start every Wednesday at 10:30
AM and run until about 10:50 AM
While normal exercise is running, the “Time
Remaining” will display the approximate number of
minutes left before exercise is completed.
If it is desired to exercise the HTS as well during
the exercise cycle, then continue with the enabling of
“transfer on exercise” described below.
Move the cursor to the “Xfer On Exercise” field on
the third line.
Press the “ENTER” button to enter edit mode.
32
General Information
H-100 Control Panel Technical Manual
To Next Page
Loading...