Generac Power Systems iQ3500

adamwyattJul 27, 2025

How to clean Generac Power Systems iQ3500 Portable Generator?

A
Alexander DavidJul 27, 2025
To prevent improper operation and equipment damage, it is important to regularly clean your Generac Power Systems Portable Generator. Here’s how to do it: * Clean the generator daily or before each use to remove dirt and debris. * Keep the area around and behind the muffler free from combustible materials. * Inspect all cooling air openings on the generator. * Use a damp cloth to wipe exterior surfaces clean. * Use a soft bristle brush to loosen any caked-on dirt or oil. * Use a vacuum to pick up loose dirt and debris. * Low-pressure air (not exceeding 25 psi) can be used to blow away dirt. * Inspect cooling air slots and openings on the generator.

Generac Power Systems iQ3500 Specifications

General

Generator Type	Inverter
Fuel Type	Gasoline
Weight	109.1 lbs
Dimensions	22.2 x 17.3 x 20.5 in
Engine Displacement	149 cc
Voltage	120 V
Wheels	No
CO Sense Technology	Yes
Starting Watts	3500 W
Running Watts	3000 W
Fuel Tank Capacity	2.6 gal
Engine	OHV
Peak Watts	3500 W
Outlets	2x 120V 20A (5-20R) Duplex, 1x 120V 30A (L5-30R)
Outlet Types	5-20R, L5-30R

Summary

Section 1 Introduction and Safety

Introduction

Read and understand the manual thoroughly before use.

Safety Rules

Manufacturer cannot anticipate every circumstance; observe alerts carefully.

Safety Symbols and Meanings

Explains DANGER, WARNING, CAUTION definitions and symbols.

Exhaust and Location Hazards

Hazards related to generator exhaust and placement.

Electrical Hazards

Risks associated with electrical connections and current.

Section 2 General Information and Setup

Know Your Generator

Information about the generator's specifications and capabilities.

Emissions

Compliance with environmental emission standards.

Connection Plugs

Details about the different AC and USB power outlets.

Digital Display Meter

Explanation of the meter's functions and information display.

OFFONCHOKE Dial

Controls for engine start, stop, and choke operation.

USB Outlets

Information on charging electronic devices via USB.

Economy Switch

Modes for optimizing generator operation and noise.

Generator Status Lights

Explanation of indicator lights for generator status.

COsense

Carbon Monoxide Detection and Shut-off System details.

Circuit Protectors

Information on AC receptacle protection and resets.

Remove Contents from Carton

Steps to open carton and verify contents.

Battery Cable Connection

Instructions for connecting the battery cables.

Section 3 Operation

Operation and Use Questions

Contact for questions about operation and maintenance.

Before Starting Engine

Pre-start checks including oil and fuel levels.

Prepare Generator for Use

Steps to prepare the generator before starting.

Grounding the Generator When In Use

Proper grounding procedures for safe operation.

Know Generator Limits

Understanding wattage capacity to prevent overload.

TransportingTipping of the Unit

Guidelines for safe transport and handling.

Starting Pull Start Engines

Instructions for starting the engine using the recoil starter.

Starting Electric Start Engines

Instructions for starting the engine using the electric start.

Generator Shut Down

Procedures for safely shutting down the generator.

Starting Hot Engines

Specific instructions for starting a warmed-up engine.

Low Oil Level Shutdown System

How the low oil sensor functions and prevents damage.

Parallel Operation

Connecting two generators for increased power.

Section 4 Maintenance and Troubleshooting

Maintenance

Importance of regular maintenance for performance.

Preventive Maintenance

Cleaning and inspection procedures for optimal operation.

Engine Maintenance

General engine servicing recommendations.

Engine Oil Recommendations

Specific oil types and quantities for the engine.

Inspect Engine Oil Level

How to check the engine oil level before use.

Change Engine Oil

Step-by-step guide for changing the engine oil.

Service Spark Plug

Procedures for inspecting and replacing the spark plug.

Inspect Muffler and Spark Arrestor

Checking the muffler and spark arrestor for damage.

Clean Spark Arrestor Screen

Cleaning the spark arrestor screen every 50 hours.

Air Filter

Servicing the air filter for proper engine performance.

Valve Clearance

Checking and adjusting valve clearance for engine longevity.

Storage

General guidelines for storing the generator.

Prepare Fuel SystemEngine for Storage

Steps to prepare the unit for long-term storage.

Troubleshooting

Common problems and their solutions.

Generac Power Systems iQ3500

Table of Contents

Questions and Answers: