Maintenance
26 Owner’s Manual for MLT Light Tower
• Check the coolant level daily by inspecting the
level in coolant overflow jug located near the
radiator. Refer to the engine operator’s manual for
coolant recommendations and proper mixture.
Normal operating level is between the ‘full’ and
‘add’ markings on the overflow jug.
• AFTER ENGINE IS STOPPED AND
COMPLETELY COOL, coolant may be added
directly to the coolant overflow jug.
•
Check the oil level daily. Refer to the engine
operator’s manual for the appropriate oil specification.
Verify the oil is correct for special operating conditions
such as a change in season or climate.
•
DO NOT
start the unit if the engine oil level is below
the add mark on the dipstick.
•
Normal operating level is in the cross-hatch pattern
between the full and add markings on the dipstick.
•
A
dd oil only if the oil level is below the add mark on
the bottom of the cross-hatch pattern on the dipstick.
DO NOT OVERFILL
the crankcase.
• Check the fuel level.
• If the unit is connected to a remote start or transfer
switch, make sure the remote switch is also off and
tagged.
NOTE: If the engine was run out of fuel or the fuel tank
was drained, it may be necessary to bleed the fuel lines.
Refer to the engine operator’s manual supplied with the
unit.
Basic Maintenance Schedule
Refer to the original equipment manufacturer’s operating
manual for a complete list of maintenance requirements.
Failure to comply with the procedures as described in the
engine operator’s manual will nullify the warranty,
decrease performance and cause equipment damage or
premature equipment failure. Maintenance records may
be required to complete a warranty request.
Use the schedule in the following table as a guide for
regular maintenance intervals. For additional or
replacement copies of the engine operator’s manual,
contact a Generac Mobile Products Authorized Service
Dealer.
To Next Page
Loading...
Need help?
General
