EasyManuals Logo

Generac Power Systems Portable Generator User Manual

Generac Power Systems Portable Generator
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
5,000 Watt Portable Generator
TROUBLESHOOTING
Problem
Cause
Solution
Engine is running, but
no AC output is
available.
1. Circuit breaker is open.
2. Poor connection or defective cord set.
3. Connected device is bad.
4. Fault in generator.
1. Reset circuit breaker.
2. Check and repair.
3. Connect another device that is in good
condition.
4. Contact Generac service facility.
Engine runs good but
bogs down when
loads are connected.
1. Short circuit in a connected load.
2. Generator is overloaded.
3. Engine speed is too slow.
4. Shorted generator circuit.
1. Disconnect shorted electrical load.
2. See “Don’t Overload the Generator” on
page 8.
3. Contact Briggs and Stratton service
facility.
4. Contact Generac service facility.
Engine will not start;
or starts and runs
rough.
1. Rocker switch set to “
Off
”.
2. Dirty air cleaner.
3. Out of gasoline.
4. Stale gasoline.
5. Spark plug wire not connected to
spark plug.
6. Bad spark plug.
7. Water in gasoline.
8. Overchoking.
9. Low oil level.
10. Excessively rich fuel mixture.
11. Intake valve stuck open or closed.
12. Engine has lost compression.
1. Set switch to “
On
”.
2. Clean or replace air cleaner.
3. Fill fuel tank.
4. Drain gas tank and fill with fresh fuel.
5. Connect wire to spark plug.
6. Replace spark plug.
7. Drain gas tank; fill with fresh fuel.
8. Set choke to “Off” position.
9. Fill crankcase to proper level.
10. Contact Briggs and Stratton service
facility.
11. Contact Briggs and Stratton service
facility.
12. Contact Briggs and Stratton service
facility.
Engine shuts down
during operation.
1. Out of gasoline.
2. Fault in engine.
1. Fill fuel tank.
2. Contact Briggs and Stratton service
facility.
Engine lacks power.
1. Load is too high.
2. Dirty air filter.
3. Engine needs to be serviced.
1. See “Don’t Overload the Generator” on
page 8.
2. Replace air filter.
3. Contact Briggs and Stratton service
facility.
Engine “hunts” or
falters.
1. Choke is opened too soon.
2. Carburetor is running too rich or too
lean.
1. Move choke to halfway position until
engine runs smoothly.
2. Contact Briggs and Stratton service
facility.

Other manuals for Generac Power Systems Portable Generator

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Generac Power Systems Portable Generator and is the answer not in the manual?

Generac Power Systems Portable Generator Specifications

General IconGeneral
BrandGenerac Power Systems
ModelPortable Generator
CategoryPortable Generator
LanguageEnglish

Related product manuals