ELECTRICAL REQUIREMENTS
Use a properly grounded three-prong outlet to reduce the hazard of electrical
shock.
The slicer should be placed close enough to the electrical power supply so that
an extension cord will not be needed. It is designed to be used on 115 Volt,
A.C., 60 Hz power source, as indicated on the Data Plate affixed to the back of
the unit. Be sure that the voltage is the same before plugging the slicer into the
outlet. To operate the unit on other voltages, the slicer must be returned to the
factory for modification.
All electrical connections must be made in compliance with all applicable local
electrical codes, as well as the latest edition of the National Electrical Code
(NFPA 70).
11
To Next Page
Loading...
Need help?
General
