GEM120 Mixer Operation Instruction
edition a
3 of 9
① Standard power supply 110V/60Hz AC.(Please use a plug with 3 wide
contacts and good grounding.)
②
Installation of Mixer: Put the stirri
ng shaft 2 in Mixer 3 and rotate it in
clockwise direction.
③
Starting procedure: Pull the gear change hand lever 1 to position 1
before
staring, Safe hood is in closed state. Then turn on the power switch 5, after
the mixer is in normal operation, set the speed required.
④ Speed transformation: If you want to change th
e speed, please pull the
bent lever 6 to the lowest point ,after pull the gear change hand lever 1 to the
positi
on required, then pull the bent lever 6 to the highest point and lift the
support 7 to the highest position. The machine can be in normal operation at
this time.
⑤Installation procedures for meat Mincer head: stop operation first ,loose
stud bolt and lift the top cover of its head. Then put on the mincer and tighten
the stud bolt.1
st
speed should be used for mincing meat.
⑥Shutting down: When the operation is completed, turn of
f the power switch
5 first, then pull the gear chan
ge hand lever 1 to position 1, and pull back the
hand lever 6 to the lowest point and finally disconnect power supply.
5、Accessories and Functions
①
Spherical mixer: Used for stirring of liquid materials, su
ch as cream and
egg.
②
Plate mixer: Used for stirring of paste, powder, and fragm
ental materials,
To Next Page
Loading...
Need help?
General
