WARNING
GENERAL WARNING. INDICATES INFORMATION
IMPORTANT TO THE PROPER OPERATION OF THE
EQUIPMENT. FAILURE TO OBSERVE MAY RESULT
IN DAMAGE TO THE EQUIPMENT AND/OR SEVERE
BODILY INJURY OR DEATH.
WARNING
ELECTRICAL WARNING: INDICATES IMPORTANT
INFORMATION RELATING TO POSSIBLE SHOCK
HAZARD. FAILURE TO OBSERVE PROPER PRE-
CAUTIONS MAY RESULT IN DAMAGE TO THE
EQUIPMENT AND/OR SEVERE BODILY INJURY OR
DEATH
.
CAUTION
GENERAL CAUTION: INDICATES INFORMATION
IMPORTANT TO THE PROPER OPERATION OF THE
EQUIPMENT. FAILURE TO OBSERVE THIS CAUTION
COULD RESULT IN DAMAGE TO THE EQUIPMENT
GSE-109-110-112 SLICER
3
P/N GENSLICERMAN
RevA 10-2011
Throughout this manual, you will find the following safety words and symbols that signify important safety issues
with regards to operating or maintaining the unit.
WARNING
HOT SURFACE WARNING. INDICATES INFORMA-
TION IMPORTANT TO THE HANDLING OF EQUIP-
MENT AND PARTS. FAILURE TO OBSERVE CAU-
TION COULD RESULT IN PERSONAL INJURY.
IMPORTANT SAFETY INFORMATION
• Read all instructions before using equipment.
• For your safety, the equipment is furnished
with a properly grounded cord connector. Do
not attempt to defeat the grounded connector.
• Install or locate the equipment only for its
intended use as described in this manual. Do
not use corrosive chemicals on or in this
equipment.
• Keep cord away from heated surfaces.
• Do not immerse cord or plug in water.
• Do not operate this equipment if it has a dam-
aged cord or plug; if it is not working proper-
ly, or if it has been damaged or dropped.
• This equipment should be serviced by quali-
fied personnel only. Contact the nearest
General authorized service facility for repair.
• Do not block or cover any openings on the
unit.
• Do not allow cord to hang over edge of table
or counter.
• GSE-112 is equipped with a 250 Watt, motor that
is
completely enclosed, permanently lubricated
and thermally protected motor
• Cut Capacity: 9” x 7” (229mm x 178mm)
• Cut Thickness: 9/16” (143mm)
GENERAL PRODUCT INFORMATION
(CONTINUED)
In addition to the warnings and cautions in this manual, use the following guidelines for safe operation of your new
General product.
• Knife Diameter: 12” (305mm)
• Dimensions: 20” W x 22” D x 18” H
(508mm W x 559mm D x 457mm H)
To Next Page
Loading...
Need help?
General
