MAINTENANCE TIPS
When the icon appears at the upper right of the display, it’s time to
replace the 9V battery that powers the meter (although measurements will
remain valid for several hours after the icon first appears). To replace the
battery, follow the Setup Instructions on p.7.
When the tips of the meter’s factory-installed 5mm test pins show signs of
wear, replace them with a pair of 10mm or 15mm pins included in the case.
Remove the battery when storing the meter for an extended period of time.
Do not drop or disassemble the meter or immerse it in water.
WARRANTY INFORMATION
General Tools & Instruments’ (General’s) MMH800 4-in-1 Pin/Pad RH Moisture
Meter is warranted to the original purchaser to be free from defects in material
and workmanship for a period of one year. Subject to certain restrictions,
General will repair or replace this instrument if, after examination, the company
determines it to be defective in material or workmanship
This warranty does not apply to damages that General determines to be from
an attempted repair by non-authorized personnel or misuse, alterations, normal
wear and tear, or accidental damage. The defective unit must be returned to
General Tools & Instruments or to a General-authorized service center, freight
prepaid and insured.
Acceptance of the exclusive repair and replacement remedies described herein
is a condition of the contract for purchase of this product. In no event shall
General be liable for any incidental, special, consequential or punitive damages,
or for any cost, attorneys’ fees, expenses, or losses alleged to be a
consequence of any damage due to failure of, or defect in any product
including, but not limited to, any claims for loss of profits.
11
To Next Page
Loading...
Need help?
General
