MAINTENANCE TIPS
• The camera at the tip of the probe is a
sensitive, sophisticated device. Do not
use the probe as a hammer or to clear
debris.
• Do not insert or bend the probe by
force. Over-bending any section of the
probe to a radius of less than 2 in.
(50mm) many permanently damage
delicate internal cables.
• Remember to power off The
PalmScope after each inspection
session.
• Do not get water on the LCD.
• Do not bring the camera into contact
with acid, fire or hot objects by using
the probe in a corrosive or extremely
hot environment.
• Avoid getting oil or gas on the camera
head by shutting off vehicles during
inspections.
• If condensation forms inside the
camera lens, let it evaporate before
using the system again.
• Remove the batteries if planning to
store the unit for months or longer.
20
To Next Page
Loading...