FIG. 11
LUBRICATION AND MAINTENANCE
Your new slicer will offer years of maintenance free operation
with proper care and use. Your motor needs no lubrication. To
insure continued smooth operation, the platform guide rod
should be lubricated about every two months by applying about
ten drops of lightweight oil Item (12) fig. 13.
CLEANING
Do not immerse assembled slicer or base assembly in water. Keep
spray cleaners and running water away from switch area, pully/belt
cover and motor mounting/housing area. Do not use abrasive
cleaners.
1. Wash base with hot soapy water and dry thoroughly.
2. Clean all remaining parts with hot soapy water and dry.
3. When cleaning sharpener be sure stone and deburrer plate is free
of grease and dry thoroughly.
To Next Page
Loading...
