MAINTENANCE (continued)
4. Slide the knife sharpener down with the knife between the
sharpening and deburring stones.
5. Plug in the machine and set the power switch to ON. (I)
6. Sharpening stone will be engaged. Run for 5 seconds,
NOTE: Sharpening stone must rotate during sharpening operation.
Remove sharpener and lubricate stone shaft if necessary.
then:
7. Press the deburring stone button (on front of sharpener) for 2-3
seconds.
NOTE: Deburring stone must rotate during deburring operation.
Remove sharpener and lubricate stone shaft if necessary.
8. Continue pressing deburr button while red button (0) is pushed to
stop blade.
12
To Next Page
Loading...
