MAINTENANCE (continued)
8. Set the power switch to OFF and unplug the slicer.
9. Remove the sharpener by raising, rotating counter-clockwise
90° and continue raising. Clean both sharpening and deburring
stones with the wire brush.
10. Remove the knife cover, clean the knife, and re-install the cover, as
described in the Cleaning Section.
11. Remove, clean and re-install the knife wiper, as described in the
Cleaning Section,
NOTE: Be sure that all steel particles from grinding have been
removed, to prevent contamination of food.
12. Re-install the knife sharpener by sliding the sharpener shaft into the
mounting bracket, rotate 90° counter-clockwise and continue pushing
down. The sharpening and deburring stones will be in the back, behind
the knife.
PARTS REPLACEMENT AND SERVICE
PARTS REPLACEMENT
Use the replacement parts list and the parts distributors list included in
the Owner's Information Packet to order spare parts. Specify the part
number and part name.
SERVICE CENTER LIST
For repair consult the factory-authorized service center list included in the
Owner's Information Packet for the closest service center.
13
To Next Page
Loading...
