Version: 2020-09-04
103
Copyright of the European Union is effective (Copyright EU) (c) 2019 GENEREX Systems GmbH, Hamburg, Germany, All rights reserved
TEL +49(40)22692910 - EMAIL generex@generex.de - WEB www.generex.de (This and all other product datasheets are available for download.)
CS141: Setting up the GSM modem for serial usage
For this configuration step, navigate to the following menu
Connect the COM port of the modem to COM2 interface of the CS141 and connect the power adapter. After connecting, open the
CS141 system tab Devices. At COM-Port 2, Select GSM Modem
The GSM modem symbol should appear in the upper bar and show the quality of the signal accordingly:
In
addition, the CS141 will display the system tab GSMModem:
Serial COM port connection
To use a serial connected GSM modem, select com as operating mode.
If necessary, adjust the values for baud rate parity and stop bit. Please note:
default values in normally represent the optimal setting and do not need to be
changed.
Using an IP modem
As special feature the CS141 is the support of a connection via LAN. COM2 is not necessary and can be used for other external
devices. Under Mode, select IP. Enter the IP address and port number the CS141 will be able to access the IP modem.
To Next Page
Loading...
