Version: 2020-09-04
104
Copyright of the European Union is effective (Copyright EU) (c) 2019 GENEREX Systems GmbH, Hamburg, Germany, All rights reserved
TEL +49(40)22692910 - EMAIL generex@generex.de - WEB www.generex.de (This and all other product datasheets are available for download.)
Valid IP address can be obtained by local administrators. if used, the CS141 will pass the data to the IP modem.
Job configuration using an SMS
Under UPS event handling, choose the event Powerfail.
Press + to begin with the job configuration dialog
Choose the job Send SMS.
SMS text allows you to enter a small text message.
Under Phone, enter the mobile phone number of the SMS receiver.
Ensure there are no spacers at the phone number you entered.
Use Timing to configure how often an SMS should be sent.
Press Save to finish job configuration.
The example dialog screenshot job will be triggered in case of a power fail
occurs and send an SMS. If several parties need to be informed, define a
separate job for each mobile number.
When you need an sms if other devices are triggered
Any device that is listed with a system event can be used to trigger an sms job. In this example, a buzzer will be used to trigger an sms.
At the event RELAY ON, click +
As Job, choose SMS, enter the text message and a valid
phone number.
As a consequence, the event chain will be shown as
followed:
Because there is a power fail, the buzzer is on and the
relay is on. Because the Relay is on, the SMS will be sent
with a custom text and logged accordingly
Note:
These event chains are very capable: In theory, it is possible to set up very complex event chains, where a job triggers the next event,
etc. – you can use inputs and outputs to communicate all over the IT without the need of a network: “High/Low” or “ON/OFF” can trigger
many thins and produce complex notification alerts.
But be carful when using long event chains: They may brake if a single device is not avaible or configured accordingly.
To Next Page
Loading...
