Version: 2020-09-04
109
Copyright of the European Union is effective (Copyright EU) (c) 2019 GENEREX Systems GmbH, Hamburg, Germany, All rights reserved
TEL +49(40)22692910 - EMAIL generex@generex.de - WEB www.generex.de (This and all other product datasheets are available for download.)
Webserver
For this configuration step, navigate to the following menus:
Note:
If possible, do not disable the web server!
In order to fit to some high security-compliance conditions, it may be desirable that the web interface of CS141 has to be switched off
after configuration work. The CS141 operates exactly "as configured". But it will be a little bit awkward if you need to change or add
settings afterwards.
For security reasons, there is no console access. Configuration work will be done via a standardized web interface.
Webserver setting
HTTP or HTTPs - Port settings
Setting up the HTTP port
The international standard for web access is port 80 - normally this port does not have to be changed. Anyway, since this is not a fixed
standard, your IT infrastructure manager may use settings that differs. If this is necessary, you may use this setting to fit to your IT
infrastructure right here.
Please note, if you use a custom port setting, you need to name the according port for web access.
o 192.168.3.1:85
In this example, the WEBMANAGER will only be accessible at the IP 192.168.3.1 and the port 85. With port 80, you would run into an
error message that is generated by your web browser.
Der HTTPs Port
In case of using HTTPs, the standard port is port 443. Like the HTTP port, you may use this setting to define custom ports for HTTPs
access.
Note:
As soon as force https is active, https:// is mandatory for a direct web access to the CS141. If you miss to use this syntax, there are two
different types of web browser behavior:
Connection Timeout
Since CS141 answers in case of a HTTPS queries, the web browser waits some time and shows a connection timeout issue.
Forwarding (depends on which web browser is in use)
If several CS141 in your network are configured to use https only, your web browser may think you entered the wrong IP address and
forwards you to another device.
To Next Page
Loading...
