Version: 2020-09-04
52
Copyright of the European Union is effective (Copyright EU) (c) 2019 GENEREX Systems GmbH, Hamburg, Germany, All rights reserved
TEL +49(40)22692910 - EMAIL generex@generex.de - WEB www.generex.de (This and all other product datasheets are available for download.)
Trap receiver test
The Trap receiver can be subsequently tested by pressing the test button. The corresponding test message should be displayed directly
in your management program.
Note:
Trap messages are automatically generated messages that do not request confirmation - therefore an agent does never know if his trap
message have arrived. Du to this fact, a reception logging is not possible.
Configurating SNMP v3
The overview shows all configured users:
Since SNMPv3 is user-based, you need to configure single users instead of communities. Click + to configure a new user:
User
SNMP v3 dispenses with the possibility of setting up authorized IP addresses and user groups. Administrators need to add a local user
inside the CS141 device.
To Next Page
Loading...
