EasyManua.ls Logo

GENERGY ISASA - Page 39

GENERGY ISASA
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
English
It is not necessary to use the choke if the engine was shut down recently and is
still warm.
4 Place the engine's ignition switch to the “ON” position.
5 Pull the startup handle slowly and until the end to calculate the maximum
length of the rope (and do not exceed it later when pulling vigorously), then
allow the rope to coil back.
Pull softly again until you notice slight resistance, now allow the rope to coil
back and pull vigorously to start up the engine.
Allow the rope to coil slowly without hitting the equipment. If you were unable to
start up in the first try, repeat the operation.
CHOKE
IGNITION SWITCH

Table of Contents

Related product manuals