10
• Do not use the system with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
• Do not use the brine tube, injector body, or other connectors on the Genesis 2 Iron Pro Max valve as a
handle to carry the system.
• Ensure there is salt in the brine tank at all times when this valve is used for softening. The brine tank
should contain clean water softening salt only, at least 99.5% pure. Only use clean water softener
salt in pellet granular or block form.
• When there is moderate to high turbidity, a filter should be installed before the water softening system
on the inlet side.
• If the water pressure exceeds 120psi, a pressure reducing valve must be installed before the water inlet.
If the water pressure exceeds 80 psi, installing a pressure reducing valve before the water inlet is highly
recommended. If the water pressure is under 20 psi, a booster pump must be installed before the
water inlet.
• Replacement parts for the valve should only be purchased through Discount Water Softeners resellers.
Electrical components, such as transformers, are specific to the Genesis 2 Iron Pro Max valve from
Discount Water Softeners.
• Regular interval monitoring of the water quality and work environment is recommended to ensure
proper operation of the valve and system.
• Any modification to Discount Water Softeners equipment, which is outside the standard scope of
supply, voids the product warranty.
• Discount Water Softeners equipment, like all modern electronic devices, can be damaged by electrical
surges or brown outs. Every effort has been taken to harden the circuits, by design, to protect against
such events. These precautions, or even additional surge protection, are not 100% effective. Therefore,
equipment damage caused by abnormal electrical events is not covered by warranty.
Genesis
2 Iron Pro Max Water Softener and Iron Filtration System Manual
To Next Page
Loading...