Genesis GHD1260 - Forward;Reverse Lever; Mode Selector Switch

English
1⁄2” 6 Amp Dual Purpose Hammer Drill
Operator’s Manual GHD1260

To start 
To stop
“LOCK-ON” BUTTON


To lock the trigger “On”


 CAUTION:
Use caution when locking the tool in the “ON” position and maintain a firm grasp on the tool.
 WARNING:
If the “Lock-On” button is continuously being depressed, the trigger cannot be released.
SPEED CONTROL DIAL



To preset a desired RPM


Once you’ve dialed in the desired drill speed

FORWARD/REVERSE LEVER





(*Note: with the drill chuck pointing away from you)
 CAUTION:
Do not change the direction of rotation until the tool comes to a complete stop. Moving the “forward/reverse” lever
while the drill chuck is rotating can cause damage to the tool.
 CAUTION:
Always check the direction of rotation before tool operation.
 CAUTION:
This drill is not designed for hammering in the reverse or counter-clockwise direction. Failure to comply with this
caution may cause property damage.
MODE SELECTOR SWITCH






 